SLF SLI Flow Sensor
[available since BMT Software version 0.224]
Read the section about Adding a new AddOn Device.
Each sensor needs to be licensed for usage with the software.
|Start measurement||Starts the sensor measurement|
|Calibration||Sets the calibration media for the sensor|
|Sampling interval [ms]||Setting the sample interval in milliseconds for the sensor measurement starting from 5 ms.|
A fast sampling interval results in a high load of CPU and RAM and some computer reaches their capacity for drawing the values into the chart.
|Totalizer||Using the totalizer from the sensor, it allows to start, stop and reset the flow volume measured.|
|Chart||The chart only works with a sampling interval starting from 10ms.|
A fast sampling interval results in a high load of CPU and RAM and some computer reaches their capacity.
|Flow||Showing the last measured flow value|
|Temperature||Showing the last measured temperature value|
|Flow per minute||According to the interval selected the value, shown is the flow rate during the interval calculated by the measurement values from the software.|
|Scale chart for flow||The maximum and minimum chart values can be set to the sensor max. value (no selection) or can be scaled to the max. and min. measured values (selected).|
|Table||The measured flow values will be logged in the table.|
This function is only available starting from 100 ms sampling interval time to reduce CPU and RAM load.